Guaranteed Accomplishment with Newest Oct-2022 FREE HP HPE0-V14 [Q27-Q51]

NO.27 A nigh school is implementing a DHCP servers to support then production environment. They have the following requirements
* six rack servers, each with 1 CPU from Intel, at least 256GB of RAM. FC Dual Port HBA
* HPE Nimble AF20 with 17TB useable capacity
* integration into their existing HPE FlexFabric 5710 and HPE SN30O0B Fibre Channel SAN switches
if the customer needs more capacity in the future, they will use scale-out growth. Which server model should you recommend to this client?

NO.28 Read the question, and then refer to the exhibit.
<Switch-A>display interface Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state:
Administratively DOWN Line protocol state: DOWN IP packet frame type: Ethernet II, hardware address:
d894-03fb-793d Description: Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK_SFP_PLUS Unknown-speed mode, unknown-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100% Multicast max-ratio: 100% Unicast max-ratio: 100% PVID: 1 MDI type: Automdix Port link-type: Trunk VLAN Passing: 10, 20 VLAN permitted: 10, 20 Trunk port encapsulation: IEEE 802.1q Port priority: 0 Last link flapping: 0 hours 0 minutes 18 seconds Last clearing of counters: Never Peak input rate: 78 bytes/sec, at
2011-03-31 04:55:57 Peak output rate: 15 bytes/sec, at 2011-03-30 23:00:57 Last 300 second input: 0 packets/sec 67 bytes/sec – % Last 300 second output: 0 packets/sec 14 bytes/sec – % Input (total): 62670 packets, 8565340 bytes 0 unicasts, 0 broadcasts, 62670 multicasts, 0 pauses Input (normal): 62670 packets, – bytes 0 unicasts, 0 broadcasts, 62670 multicasts, 0 pauses Input: 0 input errors, 0 runts, 0 giants, 0 throttles 0 CRC, 0 frame, – overruns, 0 aborts – ignored, – parity errors Output (total): 3707 packets, 1294835 bytes 0 unicasts, 0 broadcasts, 3707 multicasts, 0 pauses Output (normal): 3707 packets, – bytes 0 unicasts, 0 broadcasts, 3707 multicasts, 0 pauses Output: 0 output errors, – underruns, – buffer failures 0 aborts, 0 deferred, 0 collisions, 0 late collisions 0 lost carrier, – no carrier A customer added a new switch to their network. They connected it using interface Ten-GigabitEthernet 1/0/1.
They are using VLAN 10 and 20 for the devices in their network.
The new switch was fully operational. Then, the customer experienced a power failure later that day and could not reach any device on the new switch after the power returned.
From the output in the exhibit, would could be the issue?

NO.29 A customer needs a shared storage solution for a virtualization platform that will host a database application. The customer is considering an HPE Nimble array.
Which feature would lead you to propose an HPE Nimble AF40 over an HPE 3PAR All Flash array?

NO.30 Match each characteristic to the correct storage type.

NO.31 An administrator deployed a new FlexFabric switch Into the environment and wants to collect baseline information from the switch The administrator wants to be able to use this in case there is any question from support should the administrator open a case.
Which command can the administrator use to collect support information from the switch?

NO.32 You are installing an HPE Nimble HF20 into a customer’s existing rack.
Prior to installation, what should you consider?

NO.33 When is it appropriate for a customer to implement HPE OneView Standard?

NO.34 Match the feature to the lowest iLO5 license in which it is available

NO.35 Which storage array feature records only changes made to the base volume and keeps an earlier state of the original volume?

NO.36 Match the HPE Tool with its use case. Select all that apply.

NO.37 A customer needs a new VMware environment for a critical stock trading application and will need high performance compute and low latency storage.
Identify the correct component configurations on the left and drag them to the answer area on the right. (Choose two.)

NO.38 Which protocol can be used to access a shared directory on a network-attached storage device?

NO.39 A customer with limited IT administration resources needs a complete HPE server, storage, and networking solution. The solution must be able to be deployed in an hour or less through a simple, wizard-based setup. They want to manage the HPE solution through a simple, integrated plug-in to vCenter, since their IT staff members are already familiar with vCenter.
Which HPE solution best meets the customer requirements?

NO.40 A customer needs to move from their traditional tape-based backup infrastructure to a standalone application to disk based backup solution using HPE StoreOnce. The environment does not use a hypervisor.
The customer has the following goals for their long-term backup retention:
retain data for over two years at low cost
data is archival and rarely accessed, if ever
Which HPE StoreOnce components can help meet the customer goals in the most cost effective manner? (Choose three.)

NO.41 Refer to the exhibit.

When performing a code upgrade on an HPE Nimble array, you noticed a connection failure on ESX1. Refer to the exhibit showing the complete zoning configuration of one of the HPE SN3000B switches.
What should you do to ensure storage access is not interrupted when doing the next update?

NO.42 You are troubleshooting a HPE ProLiant rack-mount server. All installed server fans constantly run at 100%.
Which action should you take first?

NO.43 Match each characteristic to the correct storage type.

NO.44 A solution integrator is installing new equipment to the rack.
Click the recommended location for HPE R/T3000 Extended Runtime Module.
Hot Area:

NO.45 A customer acquires an HPE 3PAR Storeserv 8200 Solution for a data center environment with the following configuration:
2 Controllers Nodes
Physical Service Processor
2-tier configuration using 16 SSD and 12 NL HDD
2 SN3000 San Switch each with 24 FC ports
After installation and configuration, the storage is put in production. When tiering with the Adaptive Optimization SW is being performed, the customer encountered performance differential issue.
What could be the cause of this issue?

NO.46 Match the feature to the lowest iLO5 license in which it is available

NO.47 A customer needs an HPE Nimble storage solution with 100TB capacity. They want to be able to add more disk capacity if needed Which HPE tool can help you validate the proposed storage solution and that it is supported by HPE?

NO.48 Which HPE remote management tool offers simplified warranty and contract case management?

NO.49 Which information is contained in the Array Diagnostic Report? (Choose two.)

NO.50 A customer requires an entry-level, all-flash system with predictable performance at the lowest possible price. They have performance-sensitive workloads that require speed and efficiency.
Which HPE storage system needs the customer’s requirements?

NO.51 A security client needs a surveillance solution to support 239 Cameras. They expect to generate 2PB of data and require a 10Gb network infrastructure in a single rack.
Which solution should you recommend to meet the customer requirements?