[Dec-2022] DES-4421 Dumps are Available for Instant Access from Test4Cram [Q26-Q43]

QUESTION 26
What is the maximum possible weight of a fully populated MX7000 chassis?

QUESTION 27
A datacenter administrator has been tasked to perform firmware updates of the whole chassis and its components based on the latest dell.com catalog.
What is the correct sequence of actions?

QUESTION 28
An administrator is about to perform a firmware update on an MX9116n switch OS 10 from the CLI. The latest OS 10 switch firmware image has been downloaded and their TFTP server is set up.
Upon logged in with administrator credentials on the switch, which command should be used to start the update procedure?

QUESTION 29
A company receives their first MX7000 chassis. They connect all the provided power supply cables into two different PDUs on different power grids for redundancy. Each of the six power supplies is cabled and has green LEDs. One Management Module is present along with all system fans. Grid redundancy is configured as the power redundancy mode. The chassis is fully populated with six compute sleds and one IOM but only two of the six sleds will power on.
What is the possible reason for this issue?

QUESTION 30
DRAG DROP
An administrator is using the OME-M GUI to change the hostname on an unconfigured I/O module inserted in slot A1. They log on to the MX7000 chassis home page.
What is the correct order of steps the administrator should take to set the management IP address?
Select and Place:

QUESTION 31
A company receives their first MX7000 chassis. They connect all the provided power supply cables into two different PDUs on different power grids for redundancy. Each of the six power supplies is cabled and has green LEDs. One Management Module is present along with all system fans. Grid redundancy is configured as the power redundancy mode. The chassis is fully populated with six compute sleds and one IOM but only two of the six sleds will power on.
What is the possible reason for this issue?

QUESTION 32
Which feature requires an iDRAC Enterprise license for an MX sled?

QUESTION 33
At the initial release of the MX7000 for a daisy-chained configuration in a multi-chassis management group (MCM)m what is the maximum number of member chassis allowed, not counting the lead chassis?

QUESTION 34
Refer to the exhibit.

What is shown?

QUESTION 35
An administrator is configuring a fully populated MX5016s storage sled to be accessed by four MX740c compute sleds. Each compute sled has an H745P Jumbo PERC installed. The disks in the storage sled are evenly distributed across all compute sleds using a Drive-Assigned storage configuration.
What is the maximum number of disks that each compute sled can detect from the MX5016s?

QUESTION 36
Where in the OME-M Web interface can the Chassis Deployment Wizard be found?

QUESTION 37
What is a function of the Fabric Resources Director (FReD)?

QUESTION 38
Which MX7000 feature allows an administrator to virtualize network WWN and MAC addresses?

QUESTION 39
Where is a valid storage location for extracting the full MX7000 chassis logs package?

QUESTION 40
An administrator has been tasked with specifying hardware for a deployment having the following requirements:
* 4 node cluster within a single MX7000 chassis
* Each node needs a minimum of 6x 2.5″ drives
* 3 TB of memory and 64 physical CPU cores per node
What is the maximum hardware configuration that meets the requirements?

QUESTION 41
Match the M840c components to the callouts shown in the exhibit.

QUESTION 42
An administrator is connecting two MX840c to an MX5016s. The MX5016s is configured in Enclosure Assigned mode.
What should the requirements of this mode be to avoid configuration issues?

QUESTION 43
The MDB chassis tub assembly vertical distribution board provides connectivity to which chassis components?