Latest May-2023 H35-260 Dumps PDF And Certification Training [Q50-Q73]

Posted on by admin
Rate this post

Latest May-2023 H35-260 Dumps PDF And Certification Training

Check your preparation for Huawei H35-260 On-Demand Exam

The Huawei H35-260 Exam covers a wide range of topics including the principles of the transmission network, the architecture and components of the network, the types of transmission technologies, and the methods for network planning and optimization. The exam also covers the latest advancements in transmission technologies such as WDM, OTN, and MPLS-TP. Successful completion of the exam validates the candidate’s ability to work with various transmission technologies and implement them in real-world scenarios.

 

NO.50 When it is found that the local end reports the ETH_LOS alarm, the fault can be located by the switch-back method. If the alarm disappears after the ODF loops back to the local end, which of the following may be the cause?

 
 
 
 

NO.51 Which of the following descriptions is correct?

 
 
 
 

NO.52 In the PIN LTE bearer solution, if the link between the core L3 PTN node and the SGW is faulty, what are the triggering detection mechanisms and protection mechanisms?

 
 
 
 

NO.53 0TUK_LOF is a 0TUK layer alarm, which means the OTuk frame is lost, the FAS frame alignment is detected, and the alarm is reported when the frame is out of synchronization for 5ms. The alarmends after the frame synchronization state is restored for 5ms.

 
 

NO.54 Which of the following descriptions are correct?

 
 
 
 

NO.55 When the bridge is using ML learning mode, create an entry in the MAC.Address gateway depending on the source MAC map and server port. This entry applies to all VANs

 
 

NO.56 Which of the following options is not the reason for the R-LOS alarm?

 
 
 
 

NO.57 Four network elements form an STM-4 two-fiber bidirectional multiplexing section protection ring. Which of the following is the maximum service capacity on the ring network?

 
 
 
 

NO.58 If an error occurs in the SDH network, the service signal recovered after the signal is decapsulated must have an error.

 
 

NO.59 When creating a PTN tunnel, you can set the priority of the tunnel. There are 0, 1, and 7. The larger the value, the higher the priority.

 
 

NO.60 MPLS is used to label packets instead of IP forwarding. Which of the following descriptions about MPLS packet encapsulation are correct?

 
 
 
 

NO.61 Qinia technology can be used when multiple users need to share the same VCTRUNK and use the same VLANID.

 
 

NO.62 Which of the following descriptions about bit errors in the SDH network is wrong?

 
 
 
 

NO.63 Which of the following 7900 single-board software function descriptions are correct?

 
 
 
 

NO.64 In the MPLS label field of the PTN network, which item is the identification field of the stack bottom label?

 
 
 
 

NO.65 Which of the following types of protection is electrical layer protection?

 
 
 
 

NO.66 Which of the following statements about Uexpert is correct?

 
 
 
 

NO.67 Which items belong to the optical layer path in the path hierarchy of the WDM network?

 
 
 
 

NO.68 Which of the following is the destination MAC address of the Layer 2 header of the data received by the PTN960 from the LTE base station?

 
 
 
 

NO.69 During the negotiation between the two ends of the PTN LAG, the device with the smaller system priority number is the master device

 
 

NO.70 Which of the following is the frame indicated by the VC-4 J1 byte by the AU pointer of the current frame?

 
 
 
 

NO.71 The IP address of the interconnection interface generally uses a 30-bit mask. Which of the following IP addresses can be configured at both ends of the link?

 
 
 
 

NO.72 What are the possible reasons for the unsuccessful OCH creation by the path method?

 
 
 
 

NO.73 Plan the base station IP address network segment 10.1.1.0/26 Which of the following addresses can be used by the base station?

 
 
 
 

The Huawei H35-260 (HCS – Transmission) Certification Exam is designed for IT professionals who specialize in the field of transmission. The exam focuses on assessing the candidate’s knowledge and skills in various areas related to transmission, such as the principles of optical transmission, the configuration and maintenance of transmission equipment, and the troubleshooting of transmission faults. It is a vendor-specific certification exam offered by Huawei, which is a leading provider of telecommunications equipment and solutions worldwide.

To qualify for the H35-260 certification exam, candidates must have a strong background in telecommunications and networking, as well as a solid understanding of Huawei’s transmission equipment and solutions. Candidates must also have practical experience working with transmission networks and equipment, which can be gained through on-the-job experience or through specialized training programs.

 

Valid H35-260 Dumps for Helping Passing Huawei Exam: https://www.test4cram.com/H35-260_real-exam-dumps.html

         

Related Links: www.stes.tyc.edu.tw myportal.utt.edu.tt myportal.utt.edu.tt www.stes.tyc.edu.tw myportal.utt.edu.tt myportal.utt.edu.tt

Leave a Reply

Your email address will not be published. Required fields are marked *

Enter the text from the image below