[Dec 05, 2024] D-PEMX-DY-23 Exam Dumps PDF Updated Dump from Test4Cram Guaranteed Success [Q21-Q45]

Q21. During the installation of a PowerEdge MX7000, the implementation engineer notices the PSU health indicator stay on for one second, blink five times, then shut off.
What is the issue?

Q22. What can be used as the firmware update source for OME-M within an MX chassis?

Q23. Which command(s) is supported in the current PowerEdge MX Redfish implementation?

Q24. A system administrator is designing a solution for a customer who will be purchasing a large number of PowerEdge MX7000 chassis. For ease of management, they would like to have the least number of chassis management groups as possible.
What is the maximum number of MX7000 chassis that are supported in a multi-chassis management group?

Q25. How are double-width compute sleds on the MX7000 numbered from the front?

Q26. Which is the minimum iDRAC license required to use the Platform Restore feature of the Lifecycle Controller?

Q27. What types of network shares are supported for hosting the firmware catalog for a PowerEdge MX7000 chassis?

Q28. What is the maximum possible weight of a fully populated MX7000 chassis?

Q29. How can a hard reset be performed on iDRAC?

Q30. Which MX7000 component is responsible for Fabric Consistency Check?

Q31. An administrator has installed the iDRAC Service Module in the OS on a compute sled, they are unable to use its features in the iDRAC web GUI.
What is the likely cause of this issue?

Q32. Which MX7000 feature allows an administrator to virtualize network WWN and MAC addresses?

Q33. A server administrator wants to configure chassis power, thermal, and fans metric reports on a PowerEdge MX7000 chassis.
Which type of license is required?

Q34. To which component can a firmware update be applied without affecting any applications running on the server?

Q35. In addition to one compute sled, one management module, and one IOM, what is the minimum required HW configuration on the PowerEdge MX7000 to POST?

Q36. Refer to the exhibit.

A customer recently replaced all the dual-port network cards in mezzanine A with quad-port network cards across all 16 PowerEdge MX740c sleds in the two-chassis configuration. The customer can only access half of the network ports, even though the quad-port cards are visible in the iDRAC.
What actions are required to resolve the problem?

Q37. Which I/O module(s) supports Full Switch and SmartFabric operating modes?

Q38. Refer to the exhibit.

What is shown?

Q39. Which two main components comprise a Scalable Fabric?

Q40. An administrator is asked to install and power on a new MX740c sled in a PowerEdge MX7000 chassis. The administrator inserts the sled and presses the power button. The power button LED is pulsating green. After a short time, the power button turns to solid green and the server turns on.
What operation was in progress when the power button was pulsating green?

Q41. What is a function of the Fabric Resources Director (FReD)?

Q42. A technician has replaced an MX chassis tub. They complete the tub installation and power on the chassis. They notice that the KVM is no longer functional.
What should the technician do after confirming the KVM feature is still enabled in OME-M?

Q43. A system administrator must interface the compute sleds of an MX7000 chassis to a Z9432F-ON in a single SmartFabric.
Which FEM IOM is required?

Q44. In an MX7000, which components are cooled by the rear fans?

Q45. What does OBPAR allow on a PowerEdge MX750c?