[Jan 20, 2026] Get Up-To-Date Real Exam Questions for NACE-CIP1-001 with New Materials [Q34-Q50]

QUESTION 34
Common errors that may produce inaccurate readings when using a Dial-Type Magnetic Pull-Off Dry Filth Thickness (DFT) gauge include:
Select All That Apply

QUESTION 35
Surface profile describes:

QUESTION 36
Most industrial coatings are:

QUESTION 37
Daily reports are important because:
Select All That Apply

QUESTION 38
ISO SA 3 is directly equivalent to:

QUESTION 39
You are the NACE Coating Inspector on an exterior job where the contractor is not using any environmental controls, For the last several hours your reading; indicate the relative humidity is rising and the substrate temperature is dropping. The sky is clouding over and the weather forecast is for evening showers. It is now 4 PM, your readings indicate you have minimally acceptable environmental conditions, however if the current trend continues, you expect to be outside specified conditions soon. The contractor advises you he is going to mix up the next full kit to complete his for the day.
Your FIRST preformed course of action is to:

QUESTION 40
Owners hire NACE Inspectors’ with the expectation that:

QUESTION 41
Silicone coatings are typically:

QUESTION 42
When holiday testing is required the Inspector is always required to enforce NACE SP 0188:

QUESTION 43
Removal of surface contaminants is done by:

QUESTION 44
Which one of these elements is not necessary for corrosion to occur:

QUESTION 45
Non Conformance Reports are completed by the Inspector:

QUESTION 46
You are the NACE Inspector on a job where the Owner’s specification requites you to perform a twice daily check of blast pressure at the nozzle. It is now day 30 on the job and all of your readings have been within compliance. The Contractor complains that these checks taking up much time and in view of the compliant results they are unnecessary.
Your FIRST preferred course of action is to:

QUESTION 47
As a NACE Coating Inspector your responsibility with respect to safety is to:

QUESTION 48
You are the NACE Inspector on a 5000 sq. ft. job where SSPC PA 2 has been specified.
Assuming all areas are in compliance, how many gauge readings and spot measurements are required?

QUESTION 49
Which one of the following documents is the best source for coating technical data:

QUESTION 50
You ate the NACE Inspector on a job where NACE No. 2/SSPC – SP 10 has been specified. You are finding the Contractor is leaving mill scale on the on surface and as a result you have been rejecting the blast. The Contractor is very upset and has told you that the standard permits up to 5% of the mill scale to remain and still be in be in compliance with the standard.
Your FIRST preferred course of action is to: