Get 2023 Most Reliable Cisco 300-610 Training Materials [Q88-Q104]

Q88. What can be implemented on Cisco Nexus 5600 Series Switches for link redundancy within a Fibre Channel fabric?

Q89. An engineer must interconnect customer data centers by using a 10-Gbps. unicast-only, Layer 3 circuit The requirement is to stretch the Layer 2 connection over the tunnel isolate STP traffic and create more than two million logical network segments Much solution meets these requirements?

Q90. Refer to the exhibit.

A high-availability setup for iSCSI is designed with the host running ISCSI software. Each storage port on the MDS exports the same two Fibre Channel target ports with different ISCSI target names. In this design, how many ISCSI session are created from the host so that recovery occurs if any component fails?

Q91. Drag and drop the configurations from the left onto the correct policies on the right.

Q92. Which approach splits a pair of clustered fabric interconnects into two standalone devices?

Q93. An engineer must build a VXLAN flood-and-learned network. The customer requires the solution to be based on the IETF documented practice in RFC 7348. The solution must use broadcast, unknown unicast, and multicast (BUM) and include the efficient BUM and short BUM replication modes that use only shared trees. Which technology meets these requirements?

Q94. Drag and drop the data center technologies from the left onto the correct descriptions on the right. Not all technologies are used.

Q95. Drag and drop the components from the left onto the descriptions on the right that indicate what occurs to Fibre Channel fabric when that component fails.

Q96. DRAG DROP
Drag and drop the feature descriptions from the left onto the correct UCS Fabric Interconnect modes on the right.
Select and Place:

Q97. Refer to the exhibit.

The FCoE packets fail to be forwarded through the switch. What is the minimum MTU QoS requirement for the FCoE to work?

Q98. Which authentication software natively runs within the CLI of Cisco NX-OS devices?

Q99. Drag and drop the feature descriptions from the left onto the correct UCS Fabric Interconnect modes on the right.

Q100. Which approach splits a pair of clustered fabric interconnects into two standalone devices?

Q101. Refer to the exhibit.

An engineer is configuring a QoS policy with these requirements
Match-all AF11 traffic and set it to a DSCP value of 14.
The committed rate must be 10 Mbps with a committed burst rate of 1000 ms Drop any AF11 traffic that violates these settings.
Any traffic other than af11 must have a DSCP value of 0
The given class-map configuration already exists. Which solution must the engineer use to meet the requirements?
A)

B)

C)

D)

Q102. A network architect designs a high-availability architecture for the Cisco UCS Fabric Interconnects that are installed in a data center. The architecture must support clustering and redundancy.
Which architecture meets these requirements?

Q103. An engineer configured the OSPF protocol in the vPC topology. During the catastrophic failure of one of the vPC the member switches, the traffic was routed to a black hole. This route was caused by the long convergence time caused by the delay of the of the vPC member switch reboot. After the failure, the engineer rebooted both switches, but the secondary switch powered on before the primary one. It caused all the vPCs to be shut down due to consistency-check violations. Which two features must be used to prevent these situations from happening in the future? (Choose two.)

Q104. Drag and drop the feature descriptions from the left onto the correct UCS Fabric Interconnect modes on the right.