All Obstacles During H35-260 Exam Preparation with H35-260 Real Test Questions [Q26-Q44]

QUESTION 26
During the negotiation between the two ends of the PTN LAG, the device with the smaller system priority number is the master device

QUESTION 27
An OSN 9800 ring network is configured with ODUK ring network protection. Now a section of the optical cable on the ring needs to be reconstructed. In order to avoid frequent repetition of services during the reconstruction, which of the following operations should be performed?

QUESTION 28
The NCE network management supports a variety of external interfaces. Which of the following interfaces can be used when connecting with the network management equipment of other manufacturers?

QUESTION 29
During the debugging of the SDH system, if the E1 port reports a T-ALOS alarm, which of the following actions are meaningful?

QUESTION 30
According to the deployment plan of the existing network, which protocol does not need to be deployed for the interconnection between PTN equipment and SGW

QUESTION 31
Which of the following residual dispersion values are within the dispersion tolerance of the TN52ND2 board?

QUESTION 32
In CES SATOP encapsulation, PWE3 will transparently transmit 32 time slots of an E1 frame as a whole from one end to the other

QUESTION 33
During the normal operation of the network, the service channel protected by ODUK SNCP generates a condition for triggering protection switching, and the service has been automatically switched to the protection channel. When the fault of the working channel is eliminated, the service cannot be automatically restored to the working channel.

QUESTION 34
The signal-to-noise ratio is an important factor that limits the DWDM system, and the source of the noise is which of the following single boards are widely used in the system?

QUESTION 35
In the PTN network, the 802.1Q label header contains a 2-byte TPID. Which of the following is its standard value?

QUESTION 36
When manually configuring network element data, you need to add a single board to the network element board bitmap. Adding a single board can add a physical single board that is actually in place on the network element, but cannot adda logical single board that does not exist on the actual device.

QUESTION 37
In Huawei’s PTN7900 LTE solution, which of the following protection methods are used in the L2VPN part?

QUESTION 38
Where in the L2/L3 node is the VLAN in the Layer 2 header stripped in the packet sent by the base station in the LTE solution?

QUESTION 39
PTN’s ACR time sodium and 1588 clock can achieve time synchronization.

QUESTION 40
When creating a static tunnel, you need to specify the interface of the next hop. Which is the displayed address of the next hop?

QUESTION 41
Which of the following statements about the MPLS-TPOAM level is correct?

QUESTION 42
Which of the following boards can be inserted into the OSN 9800U64 subrack?

QUESTION 43
Regarding the comparison of Raman amplifiers with EDFAs, which of the following statements is false?

QUESTION 44
opt Datacollector supports black box fault data collection of multiple products. Which of the following products is not supported?